Quality Control Manager/Safety Officer

Summary

Developed an aptitude for observing construction activities and understands whether the task is being done correctly. Responsibilities have involved preparing and registering submittals, conducted various safety trainings, prepared, and presented Accident Hazard Analysis plans, certify QC plans and daily reports, and inspections/testing coordination.

IDEAL ROLES

Quality Control Manager/Safety Officer

EXPERIENCE

Project

Position: Quality Control Manager/Safety Officer

Responsibilities & Scope: 

Clear and grub all identified trees . Grading and leveling, install 8,000 cubic yards of fill dirt. Removal of all sidewalk and paving as indicated. Replacement of existing Storm drainage system, install new drainage devices within the track area. Removal and improvements/rerouting of municipal sewage system. Install concrete pads and accessories for dead lift and sit-ups. Coordinate high-mast lighting installation with local Electrical Utility.

Project

Position: Quality Control Manager

Responsibilities & Scope: 

Improvements to drainage system. Repair week edges of roadway, patch holes, clean surface. Install 2 inch leveling layer of asphalt. Install 2 inch pavement for new surface. Install thermoplastic edge and center lines, stop bars on roadway & parking areas. Redesign a stacking lane within the existing parking-lot for access to drive-thru.

Project

Position: Quality Control Manager/Safety Officer

Responsibilities & Scope: 

Demolition, clearing, grubbing, grading of 8 acre site. Install water retention swales along newly built roadway. Construct a 25 X 20 air conditioned Guard House at entry to site. Install 6 foot chain link fencing around perimeter and cross-fence, with 8 double gates. Erect HESCO barriers to develop containment areas within the site. Install 90 foot tall poles to support lightning suppression and grounding system. Pour 6 reinforced & grounded concrete pads for Cognex placement (Ammo Storage). Install back-up Generator pad and grounding system. Erosion Control measures included seeding and sodding.

Project

Position: Quality Control Manager

Responsibilities & Scope: 

Install (5) chillers on new poured pads with split-faced block wall on two sides. Repair Geothermal zones, and connect 3- way valves into existing mechanical room. Connect to Energy Management Control System (EMCS) Siemens Controllers . Schedule the Hydronic Testing and other inspections as required. Maintain Submittal Register, and Request for Information as Transmittals. Prepare and maintain for public use: SDS, Safety & Accident Prevention Plans. Safety Orientation meetings with all Sub-contractors prior to a new feature of work. POC for Government Assurance Personnel and independent third-party inspectors. DEWATERING --- Coordinate base Dig and State Environmental permits.

Project

Position: Quality Control/Superintendent/

Responsibilities & Scope: 

Involved with project from award until the final inspection. Provided direct assistance to multiple sub-contractors involved with this project. Coordinated repairs to all sheetrock and masonry. Removal/ reinstall all seating in auditorium after painting and new carpet was installed. Worked closely with Quality Assurance Inspector to maintain a deficiency list. Removal/installation of new windows & steel double doors with frames and hardware. Successfully demonstrated an ability to solve/resolve problems. Provided oversight for new sprinkler system, created riser. Scheduled, participated in, and distributed minutes of 3- phase meetings. Maintained Submittals and other related Quality Control Plan functions. Coordinated the installation and testing of new Fire Suppression/ Alarm and Mass Notification systems from beginning until final inspection by the base Fire Department.

Project

Position: Quality Control Manager

Responsibilities & Scope: 

Construct 10,000 square foot facility for use by Security forces. Pre-construction submittals (prepare housing & transportation plans). Project start-up activities, coordinate initial design requirements, site assessment. Develop Quality Control, Safety and Accident Prevention Plans. Mechanical, Electrical & Plumbing (MEP) Subcontractors contact list. Complete and submit Daily Reports, establish rapport with USACE construction team.

Project

Position: Quality Control/Safety Officer

Responsibilities & Scope: 

Replacement of metal standing seam roof for dormitories, fabricate customized gutters and downspouts to control water into underground drainage system beneath courtyard. Removal and installation of new roofing system for the commissary and exchange. Performed all QC functions and coordinated safety related activities. Red Zone and close-out activities including warranty manuals, O &M technical guides.

CERTIFICATIONS

Army Corps of Engineers Construction Quality Control Manager,OSHA-30 Safety for construction.

Interested in this Candidate?

Complete the form below and a member of our team will contact you to discuss your staffing needs and if this candidate or another may be the right fit.

Resume Inquiry
Name
Name
First
Last
What kind of staffing are you looking for?
Is this a GSA project?

Contact the ACE Help Desk Today!

Contact Help Desk
Please describe your help desk enquiry

Talk with an ACE Professional Today!